Seite 1 von 1

Unbalanced load case pressure

Verfasst: Mi 14. Mär 2018, 15:03
von arshia43
Hi
What is the casue for this unbalanced force warning?
1.png
2.png
Best regards
/Ali

Re: Unbalanced load case pressure

Verfasst: Mi 14. Mär 2018, 15:12
von rohr2support
Hi Ali,

The static equilibrium is not fulfilled. Ensure that the internal pressure is switched on for all super-elements except for trunions, if these are generally calculated without internal pressure. If the problem still appears I need to have a look at your *.r2w or better at your *.sip-file.

Greetings ROHR2fesu Support
Julian

Re: Unbalanced load case pressure

Verfasst: Mi 14. Mär 2018, 15:35
von arshia43
Thanks for the reply.
They are ON I think.
2.png
However, can the reason be small piece that I have between the fesus part and flange? (1mm pipe piece)?
3.png
I just try to keep the flange and have all of the bend also included.
Best regards
/Ali

Re: Unbalanced load case pressure

Verfasst: Do 15. Mär 2018, 07:53
von arshia43
H iagain
I removed the flange and small piece and add a 20mm peice after bend and it is OK now.
4.png
Best regards
/Ali

Re: Unbalanced load case pressure

Verfasst: Do 15. Mär 2018, 08:32
von rohr2support
arshia43 hat geschrieben: Mi 14. Mär 2018, 15:35 Thanks for the reply.
They are ON I think.

2.png

However, can the reason be small piece that I have between the fesus part and flange? (1mm pipe piece)?

3.png

I just try to keep the flange and have all of the bend also included.
Best regards
/Ali
Ok now I understand. The last Superelement is not a zylinder it is still the bend, The connection point from ROHR2fesu to ROHR2 always should be a zylinder to avoid this issue.