Hi
What is the casue for this unbalanced force warning?
Best regards
/Ali
Unbalanced load case pressure
-
- Beiträge: 27
- Registriert: Mi 20. Dez 2017, 08:07
Unbalanced load case pressure
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
- rohr2support
- Beiträge: 455
- Registriert: Mi 14. Sep 2011, 08:23
Re: Unbalanced load case pressure
Hi Ali,
The static equilibrium is not fulfilled. Ensure that the internal pressure is switched on for all super-elements except for trunions, if these are generally calculated without internal pressure. If the problem still appears I need to have a look at your *.r2w or better at your *.sip-file.
Greetings ROHR2fesu Support
Julian
The static equilibrium is not fulfilled. Ensure that the internal pressure is switched on for all super-elements except for trunions, if these are generally calculated without internal pressure. If the problem still appears I need to have a look at your *.r2w or better at your *.sip-file.
Greetings ROHR2fesu Support
Julian
-
- Beiträge: 27
- Registriert: Mi 20. Dez 2017, 08:07
Re: Unbalanced load case pressure
Thanks for the reply.
They are ON I think.
However, can the reason be small piece that I have between the fesus part and flange? (1mm pipe piece)?
I just try to keep the flange and have all of the bend also included.
Best regards
/Ali
They are ON I think.
However, can the reason be small piece that I have between the fesus part and flange? (1mm pipe piece)?
I just try to keep the flange and have all of the bend also included.
Best regards
/Ali
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
-
- Beiträge: 27
- Registriert: Mi 20. Dez 2017, 08:07
Re: Unbalanced load case pressure
H iagain
I removed the flange and small piece and add a 20mm peice after bend and it is OK now.
Best regards
/Ali
I removed the flange and small piece and add a 20mm peice after bend and it is OK now.
Best regards
/Ali
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
- rohr2support
- Beiträge: 455
- Registriert: Mi 14. Sep 2011, 08:23
Re: Unbalanced load case pressure
Ok now I understand. The last Superelement is not a zylinder it is still the bend, The connection point from ROHR2fesu to ROHR2 always should be a zylinder to avoid this issue.