Calculates Nozzle Stresses from Allowable Loads
Verfasst: Do 31. Mai 2012, 10:08
Dear Rohr2users
We often have the problem to determine the stresses in a vessel for which the piping has not been finished yet.
In this case we only have the allowable loads at the nozzles but don't know which load combination will really act.
The safe way is to calculate the stresses from the worst case combination of loads.
But what is the worst combination? In many cases this can be found by hand.
The exhaustive method would be to check all combination of positive and negative load directions.
ROHR2fesu allows to perform this automatically.
Please have a look at the new tutorial on:
https://www.rohr2.com/en/rohr2fesu-trai ... mples.html
See "ROHR2fesu training example 06":
Best regards
We often have the problem to determine the stresses in a vessel for which the piping has not been finished yet.
In this case we only have the allowable loads at the nozzles but don't know which load combination will really act.
The safe way is to calculate the stresses from the worst case combination of loads.
But what is the worst combination? In many cases this can be found by hand.
The exhaustive method would be to check all combination of positive and negative load directions.
ROHR2fesu allows to perform this automatically.
Please have a look at the new tutorial on:
https://www.rohr2.com/en/rohr2fesu-trai ... mples.html
See "ROHR2fesu training example 06":
Best regards