How can I make this shape in Rohr2fesu

Questions & Discussions about ROHR2 and Finite Elements
Antworten
ia3247s
Beiträge: 2
Registriert: Mi 12. Feb 2014, 16:39

How can I make this shape in Rohr2fesu

Beitrag von ia3247s »

Hello,

I am trying to make this section of my design work on Rohr2fesu but its not working I keep
getting an error that says Bauteil zu dicht an anderer Verschneidung. What am I doing wrong and How can I make it work?

Thanks in advance
Benutzeravatar
rohr2support
Beiträge: 455
Registriert: Mi 14. Sep 2011, 08:23

Re: How can I make this shape in Rohr2fesu

Beitrag von rohr2support »

Hello,

sorry this message was forgotten by the translation. „Bauteil zu dicht an anderer Verscheidung“ means that it is not possible to intersect an jacket with an superelement. In most cases the problem is that two jackets are very close to each other. See the following picture.
region_ls_intersect.png

These problems can be solved by modifying the intersection (s). In your case it is necessary to change the factor “n6”. See the following picture.
set_region_n6.png
When this is done the ROHR2fesu model should look like the following picture shows.
mesh.png
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
Benutzeravatar
rohr2support
Beiträge: 455
Registriert: Mi 14. Sep 2011, 08:23

Re: How can I make this shape in Rohr2fesu

Beitrag von rohr2support »

Find attached the ROHR2 model including the Fesu strcture.
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
Antworten