Hello,
How to include snow on vertical equipment?
If we design vertical equipment (cylinder) as a large diameter pipe or as a structural element (round shape) Rohr2 will not consider snow load since it is in vertical position.
Do we have to make LC Occasional primary loads "Snow" and to add point load (Q = Sk * A) on top of cylinder?
For example Q=0.65 (kN/m2) * 2 (m2) = 1.3 kN downward point load
LC Snow (Schnee) on vertical equipment
-
- Beiträge: 9
- Registriert: Di 24. Mär 2015, 11:58
LC Snow (Schnee) on vertical equipment
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
- rohr2support
- Beiträge: 457
- Registriert: Mi 14. Sep 2011, 08:23
Re: LC Snow (Schnee) on vertical equipment
Hi
You are right that ROHR2 will apply snow loads on horizontal pipes but not on the end.
So in order to include the snow load at the silencer top, you need to add a point load in the load-case snow.
Best regards
Rohr2 Support
You are right that ROHR2 will apply snow loads on horizontal pipes but not on the end.
So in order to include the snow load at the silencer top, you need to add a point load in the load-case snow.
Best regards
Rohr2 Support
-
- Beiträge: 9
- Registriert: Di 24. Mär 2015, 11:58
Re: LC Snow (Schnee) on vertical equipment
Thanks a lot!