Hello,
I am doing a jacket pipe system in which the outer pipe is welded to flange. How should I make that type of connection?
Thank you in advance.
Jacket pipe - Flange connection
-
- Beiträge: 13
- Registriert: Mi 2. Okt 2019, 10:58
Jacket pipe - Flange connection
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
- rohr2admin
- Administrator
- Beiträge: 631
- Registriert: Di 13. Sep 2011, 14:03
Re: Jacket pipe - Flange connection
Hello,
this is a little bit complicated and depends on what your intention is. For the pipe stress analysis it is sufficient to model this as a "full coupling".
In case you want to do a flange analysis, there are two options:
However, you can't consider the higher stiffness of the flange, nor the local stresses which might occur.
Kind regards
ROHR2support
this is a little bit complicated and depends on what your intention is. For the pipe stress analysis it is sufficient to model this as a "full coupling".
In case you want to do a flange analysis, there are two options:
- Do a finite element calculation using e.g. ANSYS
- Make assumptions and create a simplified model
However, you can't consider the higher stiffness of the flange, nor the local stresses which might occur.
Kind regards
ROHR2support
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.