Load case superposition

[vikramroy2050]

How to carry out load case superposition in ROHR2 manually?

[rohr2support]

Hi

In ROHR2 you have different options for superposition generation:
- Automatic, based on your operation and occasional load cases (assumes that all combinations between operation and occasional loads are possible)
- Semi automatic, by choosing the combinations between operation and occasional load cases that may occur at the same time
- fully manual, by specifying the "mathematic" operations on your calculated load-case results.
For the fully manual specification, please have a look a this post Understanding Superpositions.

Best regards

ROHR2 Support