Hi
When I try to have the same SIF factor for all brached that connect to a TEE, first I can choose " same data for all sections" but when I do OK and see the results or even check in the in put again, the check mark gets deactivated and sections didnot get the same SIF factor.
Is it some thing I can fix or it is a bug in Rohr2?
Best regards
/Ali
SIF factor for all branches
-
- Beiträge: 27
- Registriert: Mi 20. Dez 2017, 08:07
SIF factor for all branches
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
- rohr2admin
- Administrator
- Beiträge: 631
- Registriert: Di 13. Sep 2011, 14:03
Re: SIF factor for all branches
Hi,
this is strange, if I test it, it works as expected: On your screenshot it looks, like the program didn't find any section, as it is just grey. Do you use an updated ROHR2 version?
Best regards,
ROHR2support
this is strange, if I test it, it works as expected: On your screenshot it looks, like the program didn't find any section, as it is just grey. Do you use an updated ROHR2 version?
Best regards,
ROHR2support
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
-
- Beiträge: 27
- Registriert: Mi 20. Dez 2017, 08:07
Re: SIF factor for all branches
Perfect. But that 2 that you used in the table, have you entered that manual?
If it suppose to come manually, may be I can run the model get the SIF factor and then use it for all branched and enter them manually in the table.
Best regards
/Ali
If it suppose to come manually, may be I can run the model get the SIF factor and then use it for all branched and enter them manually in the table.
Best regards
/Ali