Welded in contour insert

Here you can post your question about ROHR2.
Antworten
arshia43
Beiträge: 27
Registriert: Mi 20. Dez 2017, 08:07

Welded in contour insert

Beitrag von arshia43 »

Hi
I try to aproximate a special tee conection that I have in a model with "Welded in contour insert" but Rohr 2 can not recognize it as a component and write no stress result on that.
1.png
2.png
Thats is a standard component in 13480 and donot think it has any shape condition.
3.png
I know that I can use Input SIF and just enter the SIF. But that is strange that it doesnot work with a standard component.

Do you have any idea why?

Thanks a lot for your consideration

Best regards
/Ali
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
Benutzeravatar
rohr2support
Beiträge: 455
Registriert: Mi 14. Sep 2011, 08:23

Re: Welded in contour insert

Beitrag von rohr2support »

Hi

The SIF for weldolets are only given in table H3 in the EN13480-3.
To activate table H3 you need to change that in the stress analysis setting
EN13480-H3.PNG
After checking the box, the stresses are calculated with ii and io and you will get results for that section.

Best regards

ROHR2 Support
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
arshia43
Beiträge: 27
Registriert: Mi 20. Dez 2017, 08:07

Re: Welded in contour insert

Beitrag von arshia43 »

Perfect.

Thanks a lot.

Best regards
/Ali
Antworten