Hi
I try to aproximate a special tee conection that I have in a model with "Welded in contour insert" but Rohr 2 can not recognize it as a component and write no stress result on that.
Thats is a standard component in 13480 and donot think it has any shape condition.
I know that I can use Input SIF and just enter the SIF. But that is strange that it doesnot work with a standard component.
Do you have any idea why?
Thanks a lot for your consideration
Best regards
/Ali
Welded in contour insert
-
- Beiträge: 27
- Registriert: Mi 20. Dez 2017, 08:07
Welded in contour insert
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
- rohr2support
- Beiträge: 455
- Registriert: Mi 14. Sep 2011, 08:23
Re: Welded in contour insert
Hi
The SIF for weldolets are only given in table H3 in the EN13480-3.
To activate table H3 you need to change that in the stress analysis setting After checking the box, the stresses are calculated with ii and io and you will get results for that section.
Best regards
ROHR2 Support
The SIF for weldolets are only given in table H3 in the EN13480-3.
To activate table H3 you need to change that in the stress analysis setting After checking the box, the stresses are calculated with ii and io and you will get results for that section.
Best regards
ROHR2 Support
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
-
- Beiträge: 27
- Registriert: Mi 20. Dez 2017, 08:07
Re: Welded in contour insert
Perfect.
Thanks a lot.
Best regards
/Ali
Thanks a lot.
Best regards
/Ali