Thrust force calculation in axial bellow modelling
Verfasst: Mo 28. Okt 2013, 07:18
Dear sir
I am new to Rohr2..I have a question regarding axial bellow modelling.
In rohr2 there are three options(entire force,bellow and no force) in thrust force calculations.
In a header calculation the anchor loads on both sides of axial bellow are very high if i use entire force option but it is very very less if i go for bellow option.
For example i am getting 101kN anchor loads with entire force option but with bellow option it is just 10kN.
The support design will also become critical for 101KN load.
The stresses are also failing in some cases if i go for entire force option but that is not the case with bellow option.
Kindly rely for this query.
Thanks in advance
S.Muthuraj
I am new to Rohr2..I have a question regarding axial bellow modelling.
In rohr2 there are three options(entire force,bellow and no force) in thrust force calculations.
In a header calculation the anchor loads on both sides of axial bellow are very high if i use entire force option but it is very very less if i go for bellow option.
For example i am getting 101kN anchor loads with entire force option but with bellow option it is just 10kN.
The support design will also become critical for 101KN load.
The stresses are also failing in some cases if i go for entire force option but that is not the case with bellow option.
Kindly rely for this query.
Thanks in advance
S.Muthuraj