hi,
I want to know why Rohr2 set sif=1.9 on a node on staight pipe , acoording to the standard, it should be 1.0.
sif value on straight pipe
- rohr2admin
- Administrator
- Beiträge: 631
- Registriert: Di 13. Sep 2011, 14:03
Re: sif value on straight pipe
Hi,
which caclulation code are you using for the calculation?
Also it matters, which presetting for a normal node you chose, in the standard setting ROHR2 creates a welding node: Best regards,
ROHR2support
which caclulation code are you using for the calculation?
Also it matters, which presetting for a normal node you chose, in the standard setting ROHR2 creates a welding node: Best regards,
ROHR2support
Sie haben keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
-
- Beiträge: 12
- Registriert: Do 7. Jun 2012, 07:03
Re: sif value on straight pipe
Hi,
The standard i choosed is ASME B31.1. The node setting is VUU.
The standard i choosed is ASME B31.1. The node setting is VUU.
- rohr2admin
- Administrator
- Beiträge: 631
- Registriert: Di 13. Sep 2011, 14:03
Re: sif value on straight pipe
Hi,
the component "VUU" is a untreated butt weld, not a the straight pipe. As normally the user doesn't insert all the assembly welds, ROHR2 creates a weld at each node.
If you don't want this, you either can change at for a node afterwards by double clicking and selecting "PGR" or you can change it in the project setting as shown above.
best regards,
ROHR2support
the component "VUU" is a untreated butt weld, not a the straight pipe. As normally the user doesn't insert all the assembly welds, ROHR2 creates a weld at each node.
If you don't want this, you either can change at for a node afterwards by double clicking and selecting "PGR" or you can change it in the project setting as shown above.
best regards,
ROHR2support