Do I need a flange analysis?
Verfasst: Fr 16. Sep 2011, 07:18
Hi
Currently I am working on a big piping system for a process piping. I used EN13480-3 for the analyis.
After I am finished with my stress analysis I was wondering about the new flange analysis module (EN1591) in ROHR2.
I have a lot of flanges in my model. Do I need to do a flange analysis for all the flanges using this module?
If not, how can I select the flanges to check?
Best regards
Currently I am working on a big piping system for a process piping. I used EN13480-3 for the analyis.
After I am finished with my stress analysis I was wondering about the new flange analysis module (EN1591) in ROHR2.
I have a lot of flanges in my model. Do I need to do a flange analysis for all the flanges using this module?
If not, how can I select the flanges to check?
Best regards